Shire Mimosa Arbour 4x2 (pressure-treated)
The Shire Mimosa Arbour is a beautiful, closed-wall, roofed, garden seat suitable for up to 2 people. It is simple, elegant and inexpensive, and is pressure-treated therefore NO additional painting is required! The Shire Mimosa arbour is available in 1 size only; 4x2, and has been manufactured from smooth planed white pine from sustainable forests. It comes pre-treated with long lasting pressure-treated preservative, therefore NO additional painting is required, however you should be aware that the Mimosa arbour shown above has been painted decoratively for photographic purposes only.
- FREE delivery*
- Manufacturers 10-year guarantee
- Low maintenance
- Pressure-treated preservative
- Modular construction
- Straightforward DIY assembly
The Shire Mimosa Arbour is manufactured with 34 x 34mm framing. It comes with 12mm thick tongue & groove cladding on the sides and the roof. The Blossom arbour is made entirely using pressure-impregnated timber and does not require painting (shown painted for photographic purposes only).
This Shire pressure-treated range is supplied pre-treated throughout with a quality, pressure-impregnated preservative.
No doors or locks are applicable to this building.
Doors and Locking System
These buildings are supplied in a flat-pack modular design with smaller panels allowing for easy transportation through your house or garage! Assembly is straight-forward for the competent DIY'er, and no professional experience is necessary. Normally 2 people can usually complete the job in 1-2 hours.
This garden building is supplied as a full kit, complete with all necessary fixings, fastenings and roofing materials. No optional extras are available for this model.
||Ext. Size (across roof) (mm)
||Size at Base (mm)
Please contact us prior to purchase if you have any queries regarding the dimensions. Information shown above has been supplied by the manufacturer, and is as accurate as possible (errors and omissions excepted), however it is intended only as a guide. We recommend that you install the building on a solid, free-draining base, with at least 60cm free space all around for maintenance and to avoid splashback. You should treat all sections with a high quality, spirit-based preservative prior to assembly, and subsequently every year in accordance with the manufacturers instructions. Please ensure that regular general maintenance is carried out on all moving parts, and that the roofing felt is regularly inspected, and replaced if required.
All products are delivered sectional/flat-packed to kerbside unless stated otherwise. Deliveries are available for most of mainland England, Wales and Scotland, however no deliveries are available to the Yellow Zone, or to any island or offshore area... please see map below, or click here for more information.
The current delivery lead time shown is typical for Red Zones, however this is approximate and cannot be guaranteed. The lead time may be longer for outlying areas. Installation is available for most delivery areas, however this will extend the lead time to approximately 28 days.